HDPE Double Wall Corrugated Pipe Plastic Drain Pipe Culvert tube
HDPE Double Wall Corrugated Sewage Pipe is made of high density polyethylene, which is co-extruded by inner and outer extruders respectively and formed in one step. The inner wall is flat and smooth, and the outer wall is corrugated. It has an annular outer wall with a hollow layer between the inner and outer walls. It has unique structure and high strength.The whole production process is: extrusion-compounding-molding-cooling-cutting-finished product.

Connection Methods:

HDPE Double Wall Corrugated Sewage Pipe Installation and Connection Instruction
1.The pipeline shall be laid on undisturbed soil foundation or backfilled and compacted stratum after slotting. The thickness of soil covering on the top of the pipeline under the roadway shall not be less than 700 mm.

2.HDPE double wall corrugated pipe can be installed in the same groove,and can be carried out according to the relevant regulations for the design and construction of common pipelines laid in the same groove.

3.When the pipeline passes through railways, high-grade road embankments and structures with obstacles,the protective pipe sleeves made of reinforced concrete, steel, cast iron and other materials shall be provided. The inner diameter of the sleeve shall be above 300mm larger than the outer diameter of the corrugated pipe, and the space between the corrugated pipe and the sleeve shall be filled with filler.

4.The width of the bottom in the groove should be determined by adding 600mm to the outer diameter of the pipe so as to facilitate manual operation at the groove bottom.

5.The slotted length should be shortened as much as possible when installation in rainy days. Slot and backfill quickly and make prevention measurements of filling with water. In case of filling with water, water shall be removed as well as the softened soil layer affected by water.Basic treatment should be made with sand and gravel or medium coarse sand.

6.The pipeline foundation design adopts cushion foundation. When the bottom of the groove is below the groundwater level, it is advisable to lay a layer of gravel or crushed stone with a thickness of no less than 150 mm and the size of gravel is 5-40 mm, and then lay a sand cushion (medium and coarse sand) with a thickness of no less than 50 mm and a total thickness of no less than 200 mm.

7.Pipeline installation can be generally installed manually. During installation, both ends of the pipeline are manually lifted to the personnel in groove. In open groove, non – metallic rope pipe is used when the groove depth is larger than 3m or pipe diameter is larger than 400mm,and make the pipe smoothly in the groove. It is strictly prohibited to hook both ends with metal ropes or throw the pipe into the groove directly. For mixing groove or support groove,it is advisable to handle the pipe intensively from one end of the groove, and transport the pipe to the installation position at the bottom of the groove.

8.Socket-ended pipe installation should be made from downstream to upstream installation in turn,with straight pipe end along the direction of water flow and socket end in reverse direction of water flow.

9.Pipe length can be cut by hand saw without roughness and damage in cutting section.

10.The following regulations shall be observed when rubber ring is used to seal the joint:
(1)Check whether the rubber ring is suitable before connection and confirm the position placed and socketed depth.
(2)Clean the socket end with cotton cloth without any soil left before connection,coat with lubricant,and aim at the straight pipe end immediately.
(3)Insert the straight pipe end into the socket end.Arrange a wooden baffle at the end of the pipe and push the pipe slowly with a crowbar.When size larger than 400mm,fasten the pipes with flexible rope,insert with manual lifting tools and construction machinery is strictly prohibited.